Unblocking the Drains: The Professional’s Ultimate Guide to Your Problems

You count on your home to be functional and safe. This means that the many systems present in your house, including your plumbing system, need to work properly. If you face drainage problems such as clogged drains in your bathroom, kitchen, or other areas of your house, you might benefit from this guide. Below are some ways you can unblock your drains.

For information on how to unblock your drains or better yet, if you can’t do the job yourself, click here and get the information/services you need to follow for unblocking the drains.

1.        The Bent Wire Hanger

Although this method is simple, it is surprisingly effective. Simply take a regular wire hanger and straighten it out as well as you can. Then bend one of its ends over, creating a small hook. Push it through the drain cover and begin fishing. You should be prepared to get all kinds of hair and unpleasant things out of the sink. You always want to pull the gunk out, not push it in further. Run warm water through the drain once you have as much out as you can and it should clear stuff up well.

2.        Boiling Water

Tips do not get any simpler than this. Put the kettle on (or use the stove or microwave) and boil up a whole lot of water. Now, pour it slowly down the drain in about three different goes, permitting the hot water to work for various seconds in between each pour. This is normally the best and quickest way of unclogging a drain. You can even reward yourself with a cup of tea if any hot water remains.

3.        The Wet & Dry Vacuum

If you have a dry & wet shop vacuum, it can turn out to be a terrific appliance for unclogging drains. First, set it to vacuum liquids. Cover the vent up to forestall a mess. Next, create the tightest seal possible over the drain. You might also want to get innovative and adapt an old plunger head for this. If the vacuum is on its highest setting, it can be powerful enough to draw the clog up the pipe and into the vacuum bag. It doesn’t work every time, however, it’s really worth a shot.

4.        Caustic Soda

Get some eye protection and rubber gloves. Caustic soda (Sodium Hydroxide) can lead to nasty chemical burns. You can get some from your local hardware store, but when managing it, always be cautious. In a mop bucket, pour 3/4 gallons of cold water and 3 cups of caustic soda. With an old wooden spoon, stir well. It’s going to start fizzing and heating up. Pour it into the blocked drain and let it be for 20-30 minutes, then empty the drain with steaming water. If needed, repeat.

5.        Cleaning the Pipe

There are some plumbing jobs might seem tough but this one isn’t. First, put an empty bucket underneath the U-shaped pipe (the trap) below the sink. The bucket will fill up with the water that spills. Using a plumber’s wrench, loosen the slip nuts at each end of the pipe. You should be in a position to complete this by hand. When the trap is free, dispose of it and flip it upside down, emptying the bucket’s content. You might additionally need to fish around inside it for debris and do the same with the pipes that have been holding it. A used toothbrush is appropriate for getting the hard gunk out. Rinse the trap with water and then put it all back together. This will do the trick in most cases.

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter Captcha Here : *

Reload Image